4 Seven User Guide | INS-SVN-USER | watsonfurniture.com
HEIGHT ADJUSTMENT
WORKSTATION TIPS
Switch Operation
The Seven Inset and Undermount Height-
Adjustment Switches have two buttons for
user operation.
Inset Switch Undermount Switch
Wellness Switch
Ensure all user power cords are long enough to reach
from outlets to worksurface in the highest adjustment
setting. Do not subject cords to any strain while
adjustment of the surface is taking place.
TECHNICAL PRODUCT SPECIFICATIONS
Range of Adjustment Electric — 28-46”
Glide Adjustment ½"
Max. Weight Capacity 250lbs*
Wire Management
Included
Ye s
Controller Up/Down
Decibel Rating 50db(A) in
typical applications
Volts 120v AC
Frequency & Phase 60 Hz, Single Phase
Amps 2 Leg — 5.0A max.
3 Leg — 10.0A max.
Watts 2 Leg — 216 W max.
3 Leg — 300 W max.
Standby 0.1W
Adjustability Speed 1.6"/sec
Duty Cycle 10%
* Includes worksurface weight (≈5 lbs/ft)
Note — Rectangular tops weigh between 47-80 lbs; a
72”x29” top weighs 71 lbs.
Always check for proper operating clearance before
placing any item on, above or below the worksurface.
To reach the desired height, press and hold either the Up or Down
arrow. As a safety feature, the users must continuously hold down
the arrow button in order for the table to move.
To Next Page
Loading...
Need help?
General
