watt box WB-OVRC-UPS-2000-1 - Battery Replacement Procedures; Battery Access Steps

pg.12
WB-OVRC-UPS-1100/1500/2000 Owner’s Manual
BATTERY REPLACEMENT (SERVICE PERSON ONLY)
The UPS is equipped with user-replaceable batteries that can be hot-swapped while connected equipment is powered from the supply outlet.
Contact WattBox Support to order replacement batteries.
NOTE: With the batteries disconnected for replacement, connected equipment is not protected from power outages.
NOTE: This UPS is equipped with internal batteries and only the service person can replace the batteries.
BATTERY ACCESS
Step 1 Step 2 Step 3
Remove the front panel cover. Disconnect the battery wires. Remove the four battery panel screws, set
the cover aside, and pull the battery tray
from the front of the UPS.
Step 4 Step 5 Step 6
Remove the top cover of the battery box.
See the opposite page for battery swap
instructions for your model.
After swapping the batteries, replace the
battery tray in the UPS and reattach the
battery cover. Tighten the screws securely.
Reconnect the battery wires.
Step 7
Replace the front panel cover.