Power saving sleep mode
①No charging (AC input + PV), no discharging (DC + USB + AC). When charging is not
connected and only the main switch is turned on: sleep after 5 minutes.
②Any charging is connected (regardless of whether there is power), and it does not sleep.
③Without any charging input,USB <5W, DC <5W, AC <25W, three conditions are met at
the same time, and sleep after a delay of 8 hours.
④The self-consumption of whole machine is less than 5mA after shutting down all switch
and sleeping;
⑤Please turn off the main power switch during transportation or it will not be used for a
long time. Self-consumption after switching off is less than or equal to 200μA.
Equipment cleaning
Please make sure that the device is disconnected from all input power and output devices.
Wipe with a clean, dry, non-soft cotton cloth. Remove all any foreign objects, dirt or other
obstructions on the vents on both sides. While cleaning foreign objects in the side vents,
do not allow debris, dirt or other blockage to enters the equipment.
Do not use corrosive cleaners or solvents.
Do not use compressed air to clean the side cooling vents, as it will cause foreign particles
to enter the interior and cause a short circuit.
⚠ Note: To avoid the risk of electric shock, do not use metal objects to clean the ports.
Storage
If it will be stored for more than 1 month, please charge it to 50% capacity and keep it
indoors, at normal temperature, and the maximum storage time shall not exceed 6 months.
Please keep it away from direct sunlight.
Excessive temperature will lead to reduced service life, overheating and fire. Extremely
cold conditions below the specified storage range can also impair the performance and
service life of the equipment. Please keep away from corrosive chemicals and gases.
After taking it out of storage, perform a visual inspection to ensure that the appearance of
the equipment and all accessories are qualified. Check the vents on the intake and
exhaust sides to make sure they are free of foreign objects.
To Next Page
Loading...