OPERATING INSTRUCTIONS
Power output attention
Press output switch to select the desired outlet type. The output port must press the
corresponding button to activate the port. When activated, the LCD display will turn on
and provide detailed information about the charging output. When no output is activated,
the LCD screen will automatically turn off.
Overload condition
When all outputs are short-circuited, the device automatically turns off the output power.
The code "E07" will be displayed on the LCD screen.
When all outputs are overloaded, the device will automatically cut off the output power.
The code "E08" will be displayed on the LCD screen.
Discharging
Press the "Power on/off" button for 2 seconds to turn on the device. Press the "Power
on/off" button for 2 seconds to turn off the device. The device uses an advanced battery
management system that allows it to charge the connected device through AC or DC
output or USB output.
How to switch frequency?
The device can intelligently identify the frequency of voltage when charging, and can
automatically set the frequency, so please charge before using. After plugging in the
charging cable, the display will show the frequency of current grid voltage if it displays "50",
it is 50Hz, if it displays "60", it is 60Hz.
You can also manually set and change the voltage frequency. Before using the power
station, please confirm the voltage frequency of your electrical equipment, 50 Hz or 60
Hz?
Then press the "Power on/off" button for 1 seconds to turn on the device. If "50" is
displayed on the LCD, it means that the operating frequency of the power station is 50 Hz.
If' 60' is displayed on the LCD screen, it means 60 Hz.
If the frequency displayed on the LCD display does not match the frequency of the local
power grid, you must change the frequency according to the following steps:
Step 1: press the button 'Power on/off' for 3 seconds to power off (the LCD display screen
will turn off). Step 2: keep pressing the button 'AC on /off' with your right finger first and
then press the button 'Power on/off' for 1 seconds with your left finger, then release the
both fingers off the buttons. You will see the frequency.
Cooling fan
The equipment is designed with an internal cooling fan to ensure that the product runs
within the proper temperature range. When the device experiences a high output load, it
will automatically turn on the fan. During discharging and charging, the fan may run
intermittently to keep the internal temperature within the operating range. When the AC
circuit is activated, the fan is likely to start to ensure normal operation.
To Next Page
Loading...