When the Cigarette Lighter Socket Output is turned on, the icon
lights up and shows the total power used by the DC output, the
current remaining time and frequency.
(Not available yet) When the wireless charge output, this label is
displayed on the LCD.
After the AC output switch is turned on, the icon lights up and
displays the total ac output power, current remaining time, and
current frequency.
When the AC switch is turned on, the display displays "OUTPUT"
and the icon.
When the device is in the AC charging state and the AC output is
turned on, the UPS mode automatically starts and this label is
displayed on the LCD.
(Not available yet) When the IoT network is normal, the icon is
always on, and when the IoT network is not connected or the icon
flashes.
When the fan is running, this label is displayed on the LCD.
When the AC output is synchronized, this identifier is displayed on
the LCD.
Smart parallel
battery pack
access status
For each connected smart battery pack, light up a battery pack
icon.
The arrow on the left of the battery pack icon indicates the
charging status. The arrow on the right of the battery pack icon
indicates the discharge status.
Intelligent
parallel battery
pack power
status time
When a smart parallel battery pack is connected, the remaining
time of electricity consumption is displayed; The remaining full
time is displayed in the charging state, and the remaining working
time is displayed in the discharge state.
Intelligent
parallel battery
pack power
information
When a smart parallel battery pack is connected, the battery
information is displayed.
When the inverter or battery pack temperature is too high, this
label is displayed on the LCD.
When the temperature of the inverter or battery pack is too low,
this label is displayed on the LCD.
If the AC or DC output is overloaded, the system automatically
turns off the output, blinks for 10S, and then turns off.
When the product fails or warns, the corresponding fault code is
displayed.
To Next Page
Loading...