CHANGE THE VOLUME ON THE LOCK
Sequence: # 0 one o the admin cod’s # one o the following codes;
0 soundless, 1 low, 2 normal
Example: # 0 3456 # 1 (the standard is code 2 normal)
ANTI MALICIOUS-USE SET UP
HIDE YOUR PIN CODE FOR OTHER PEOPLE
CHANGE BATTERIES
When this function is activated, any wrong PIN code access attempts
on ve consecutives occasions will stop the lock from working for three
minutes. All key buttons on the outside keypad will cease to function.
TO DEACTIVATE
Sequence: # 2 masterkode # 0
Example: # 2 3456 # 0
TO ACTIVATE
Sequence: # 2 masterkode # 1
Example: # 2 3456 # 1
This feature allows you to enter other numbers before and after the
code you use. This can be used, for example when you are whit others,
who do not have access to your house. If your code is for example
3456, you can enter 21345681 #. And the door will open. The lock is set
in this function at the factory.
Wattle® Door Touch & Smart
TO ACTIVATE
Sequence: # 4 masterkode # 1
Example: # 4 3456 # 1
TO DEACTIVATE
Sequence: # 4 masterkode # 0
Example: # 4 3456 # 0
Wattle® Door Pro
TO ACTIVATE
Sequence: # 5 masterkode # 1
Example: # 5 3456 # 1
TO DEACTIVATE
Sequence: # 5 masterkode # 0
Example: # 5 3456 # 0
When the battery power is low, the lock will send out eight beeps when
you enter your pin code. Then you remove the cover on the inside
module, and change the three batteries. You do not need to program
the lock again after changing the batteries.
38
To Next Page
Loading...
