Watts tekmar 294 - Settings - Security and Reset; Security Passcode Settings; System Reset Options

28
IOM-T-294 2205 © 2022 tekmar
Parameter Range Description
STEP 5 IS REPEATED FOR EACH AVAILABLE BOILER 2 TO 16
STEP 6
Commission wizard ends and all outputs are turned off.
A Commissioning Report is provided at the end of the
commissioning wizard.
The
 indicates that step was completed successfully.
The
 indicates that step was incomplete and corrective
action is required.
Parameter Range Description
SECURITY
STEP 1
Set a personal passcode. This is required when a passcode has already been set.
STEP 2 Confirm the personal passcode. This is required when a passcode has already been set.
REQUIRE
PASSCODE
Off or On
Default: Off
Select if a passcode is required to enter the Home screen.
PASSCODE Select to change the personal passcode.
RESET
FACTORY RESET
Select to load factory defaults for all settings. This does not deregister the control from the Watts OnSite application.
TEKMARNET
DEVICE RESET
Select to reset the tekmarNet communications. This removes any lost tN4 devices from the control.
Settings (8 of 8)