Wavecom WMOD2B - Resolving Communication Error Codes

5.2 The modem always returns «Error» when trying to issue a communication
A) Issue AT+CMEE=1 to have extended error code and retry
For all other codes, and/or details, see AT commands manual.
B) Additional hints
❏ Is the modem registered on the network?
Does the AT-Command AT + CREG? answers 0,1 (registered) or 0,5 (registered roaming)?
➫ If not, check that the received signal is strong enough to synchronize on the Network (use AT+CSQ).
TROUBLESHOOTING
Wavecom WMOD2B Modem 13
rorrE
edoc
citsongaiDtniH
0eruliafenohPtroppuslacinhcetruoyllaC
3dewollatonnoitarepO
4detroppustonnoitarepO
01detresnitonMIS
→ ,medomehtforedlohMISehtnidracMISehttresnI
→ .detresniylreporpdnanaelcsititahterusni,detresnisidracMISfI
11deriuqerNIPMISedocNIPretnE
21deriuqerKUPMIS )edocsihtwonkt’noduoyfiredivorpkrowtenruoyllac(edocKUPretnE
31eruliaFMIS
krowtenruoyllac,degamadMISfI.dracMISruoyfoytidilavkcehC
redivorp
61drowssaptcerrocnIderetneuoyedocehtkcehC
71deriuqer2NIPMISedoc2NIPretnE
81deriuqer2KUPMIS
sihtwonkt’noduoyfiredivorpkrowtenruoyllac(edoc2KUPretnE
)edoc
62gnolootgnirtslaiD)stigid02xam(rebmunenohpruoykcehC
03ecivreskrowtenoN