January 2001/ version 1.4
WMOi3 Integrated Modem
confidential ©
48/61
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement. Ce document est la propriété exlcusive de WAVECOM. Il ne peut
être communiqué ou divulgué à des tiers sans son autorisation préalable.
8.1.4.28.1.4.2 Terminal emulator setupTerminal emulator setup
Here below is an example based on the Windows
TM
Hyperterminal application
(terminal emulator program).
Setup:
START – PROGRAMS – ACCESSORIES – HYPERTERMINAL , then
Start the software HYPERTRM
Give the name of your choice, click on the icone of your choice, then click “OK”,
then
choose:
Connect using : direct to COM1
Properties :
choose 9600 bps – 8 bits data – no parity – 1 stop bit – hardware flow control
Click “OK”
Once Hyperterminal is open and configured, it can be used to send AT
commands to the WMOi3.
Please see the “Informative Example” annex in the AT command user’s guide to
test your WMOi3.
To Next Page
Loading...
Need help?
General
