Waveshare Pan-Tilt HAT - Assembly; Connect Servos

To Next Page

To Previous Page

Pan-Tilt HAT User Manual

Version: V1.0.0; Date: 2019.03.16 8 / 17

ASSEMBLY

Note: Before you assemble servos to Pan-Tilt HAT, please test the servo with test

codes to avoid of servo stuck when rotate

1. Connect servos to Pan-Tilt HAT

Brown wire

GND

Red wire

Yellow wire

S1/S0

You should connect the Pan servo (close to HAT board) to S1, and connect Tilt

servo (close to camera) to S0. Please adjust the angle of the servo when assembling by

using the test codes, avoiding of damaging.