Wayne-Dalton Torquemaster Plus - Pre-Installation and Parts Overview; Important Safety Instructions; Door Opening Preparation

2
NOTE: A TorqueMaster
®
Plus single spring system can be identified by the end brackets. You can identify the right hand end bracket by the disconnect cable
guide hole in the top of the bracket, as shown above. The left hand end bracket will have no disconnect cable guide hole in the top of the bracket.
2. Right Hand End Bracket:
1. Left Hand End Bracket:
2. Right Hand Spring Assembly:1. Left Hand Spring Assembly:
TABLE OF CONTENTS
TORQUEMASTER
®
PLUS REPLACEMENT SPRING COMPONENTS FOR
LEFT HAND AND RIGHT HAND ASSEMBLIES
End Bracket
End Bracket
TorqueMaster
®
Plus Warning Tags
TorqueMaster
®
Plus Replacement Spring Components 2
TorqueMaster
®
Plus End Bracket identification .......... 2
Tools Needed ............................................................. 2
Single And Double Spring TorqueMaster
®
Plus Removal 3-4
TorqueMaster
®
Plus Single And Double Spring Replacement 5-8
TOOLS NEEDED
Disconnect
Cable Guide
TORQUEMASTER
®
PLUS END BRACKET IDENTIFICATION
Power Drill Pliers/Wire CuttersRatchet Wrench
Step Ladder LevelLocking Pliers
5/8” Socket
Gloves Pencil
Flat Head Screwdriver
Tape Measure Safety Glasses
3” Extension 7/16” Wrench
7/16” Socket
Driver
Vice Clamps
Left
Right
Warning Tag