To Next PageTo Next Page
Need help?Do you have a question about the Wayne-Dalton Torquemaster 9100 and is the answer not in the manual?
General| Brand | Wayne-Dalton |
|---|---|
| Model | Torquemaster 9100 |
| Category | Garage Door Opener |
| Language | English |
Components for attaching tracks to vertical supports.
Brackets attaching vertical tracks to garage door jambs.
Rollers that fit into tracks for door section movement.
Hinges connecting door sections, some with anti-pinch.
The individual panels that comprise the garage door.
Hardware for attaching horizontal tracks to the top door section.
Structural supports for door sections, often for track mounting.
Bracket for attaching a drawbar operator to the top door section.
Vertical and horizontal guides for door roller movement.
The counterbalance spring system for the garage door.
Supports for the rear of the horizontal tracks.
Brackets securing the bottom section and attaching to vertical tracks.
Essential warnings and precautions to prevent injury during installation.
List of tools needed to complete the installation process.
Inventory of parts included with the garage door system.
Guide to identifying each section of the garage door.
Procedures for safely dismantling and removing a current garage door.
Steps to ensure the garage door opening is ready for installation.
Instructions for attaching quick-install type flag angles.
Instructions for attaching fully adjustable flag angles.
How to attach the horizontal track support angles.
Mounting instructions for quick-install jamb brackets.
Mounting instructions for fully adjustable jamb brackets.
Instructions for installing jamb brackets for windload specifications.
Procedure for securing structural struts to door sections.
How to attach the roller slides to the door sections.
Installing cable drums and track rollers for door operation.
Positioning and leveling the bottom section of the door.
Mounting the vertical tracks to the garage door jambs.
Procedure for assembling the door sections sequentially.
Installing hardware for the top door section and tracks.
Mounting the bracket for a drawbar-type garage door operator.
Positioning and securing the top section of the garage door.
Installing horizontal tracks with quick-install flag angles.
Installing horizontal tracks with fully adjustable flag angles.
Adjusting the top fixture hardware for proper alignment.
Preparing and positioning the Torquemaster spring tube assembly.
Installing drum wraps onto the spring tube assembly.
Installing the cable drum assemblies onto the winding shafts.
Attaching the end brackets to the winding shafts and jambs.
Fastening the center bracket bushing to the header.
Securing the door to prevent movement during spring winding.
Adjusting the lift cables for proper tension and balance.
Procedures for winding the counterbalance springs.
Securing the drum wraps to the cable drum assembly.
Fabricating and installing supports for the rear horizontal tracks.
Adjusting spring tension for proper door balance and operation.
Steps to reset the Torquemaster Plus safety system.
Connecting the door arm to the operator bracket.
Setting up the operator's trolley arm for correct movement.
Installing an internal lock mechanism on the door section.
Installing a pull-down rope for manual operation.
Installing a step plate onto the bottom door section.
How to properly clean the garage door finish.
Instructions for preparing and painting the garage door.
Guidelines for safe operation and routine maintenance checks.
