To Next PageTo Next Page
Need help?Do you have a question about the Wayne-Dalton Prodrive 3220C and is the answer not in the manual?
General| Brand | Wayne-Dalton |
|---|---|
| Model | Prodrive 3220C |
| Category | Garage Door Opener |
| Language | English |
Verify door operates smoothly, stays in position, and is balanced before opener installation.
Verify the garage door is a sectional type, not a one-piece door, for compatibility.
Perform two tests to ensure the door is balanced and operates smoothly.
Key safety and installation steps to follow before starting the opener installation.
Ensure proper alignment of the driver gear with the rail sprocket for gear engagement.
Reinforce the header wall for secure mounting of the front wall bracket.
Connect the rail assembly to the front wall bracket using specified hardware.
Position the motor end of the opener, supporting it to avoid door damage.
Hang the opener end from ceiling joists using perforated angles and lag screws.
Mount the wall brackets for safety sensors at the same height on both door jambs.
Connect the infrared safety sensor wires to the opener terminals, observing polarity.
Adjust sensor alignment until the indicator light on the receiving unit is steady.
Adjust the close travel to ensure the door stops on the floor with slight compression.
Adjust the open travel to stop the door at its natural fully open resting position.
Test if the door reverses upon contacting a 1-1/2" object on the floor.
Test if safety sensors reverse the door when obstructed.
Essential safety precautions for operating the garage door opener.
Fine-tune force settings for safe door reversal and operation.
Ensure the door reverses correctly upon contact with obstructions.
Address issues with the opener not responding to controls or flashing lights.
Diagnose problems with door not opening/closing fully or reversing unexpectedly.
Resolve issues related to safety sensors and obstructions.
