Wayne-Dalton Prodrive 3324B-Z User Manual

®
GARAGE DOOR OPENER
INSTALLATION INSTRUCTIONS AND OWNER’S MANUAL
Chain/ Belt Drive
Models: 3220C, 3221C, 3222C, 3224C, 3320B, 3322B, 3324B
3220C-Z, 3221C-Z, 3222C-Z, 3224C-Z, 3320B-Z, 3322B-Z, 3324B-Z
IMPORTANT NOTICE!
Read the enclosed instructions carefully before installing/operating
this garage door opener. Pay close attention to all warnings and
notes. This manual MUST be attached to the wall in close proximity
to the garage door.
Copyright 2008 Wayne-Dalton Corp. Part No. 325809 Rev.5 7/16/2008
FOR RESIDENTIAL SECTIONAL OVERHEAD GARAGE DOORS ONLY!
DO NOT USE ON ONE PIECE DOORS!
IMPORTANT! THE DOOR AND OPENER WILL NOT FUNCTION PROPERLY UNTIL
INFRARED SAFETY SENSORS ARE INSTALLED AND PROPERLY ADJUSTED!
GARAGE DOORS & OPENERS

Wayne-Dalton Prodrive 3324B-Z Specifications

General

Type	Chain Drive
Horsepower	1/2 HP
Remote Control	Yes
Security	Rolling code technology
Max Door Height	8 ft
Voltage	120V
Remote Controls Included	2

Summary

Pre-Installation Inspection

Pre-Installation

Identify Your Door

Test Your Door

Pre-Assembly Check

Important Installation Instructions

Attaching Opener to Rail

Positioning and Installing Front Wall Bracket

Attach Unit to Front Wall Bracket

Positioning Motor End of Opener

Mounting Opener End

Mounting Door Bracket

Wired Wall Station Installation

Deluxe Multi-Function Wireless Wall Station Installation

Wired Infrared Safety Sensor Installation

Installation of Wiring for Wired Infrared Safety Sensor

Connecting Wired Infrared Safety Sensor to Opener

Alignment of Wired Infrared Safety Sensors

Connecting Opener To Outlet

Connecting Trolley To Latch Assembly

Setting Trolley Close Position

Connecting Door Arm to Door

Setting Door Close Travel

Setting Door Opening Travel

Obstruction Tests

Contact Obstruction Test

Testing if the door reverses upon contact with a 1.5" object on the floor.

Safety Sensor Obstruction Test

Testing if safety sensors stop/reverse the door when obstructed.

Programming Wireless Keyless Entry

Installing Wireless Keyless Entry

Power Connection (Permanent Wiring Option)

Mounting Door Bracket To A 9700 Series Door

Mounting Door Bracket To A (9100, 9400, 9600, 5120 & 5140 Series Door)

Setting Trolley Close Position/ Connecting Door Arm

Setting Trolley Close Position/ Connecting Door Arm (Torsion Springs)

Important Safety Instructions

Operating the Wireless Wall Station

Customizing the Settings

Primary Programming for HomeLink® to the Prodrive

Alternate Programming for HomeLink® to the Prodrive

Adjustments

Opening and Closing Force

Adjusting force limits for safe door operation and reversal.

Contact Obstruction Sensing

Ensuring the opener reverses upon detecting an obstruction during closing.

Positive Mechanical Door Lock

Programming Wireless Wall Station(s) Or Transmitter(s) to Opener

Troubleshooting