Wayne-Dalton Prodrive 3222C User Manual

®
GARAGE DOOR OPENER
INSTALLATION INSTRUCTIONS AND OWNER’S MANUAL
Chain/ Belt Drive
Models: 3220C, 3221C, 3222C, 3224C, 3320B, 3322B, 3324B
3220C-Z, 3221C-Z, 3222C-Z, 3224C-Z, 3320B-Z, 3322B-Z, 3324B-Z
IMPORTANT NOTICE!
Read the enclosed instructions carefully before installing/operating
this garage door opener. Pay close attention to all warnings and
notes. This manual MUST be attached to the wall in close proximity
to the garage door.
Copyright 2008 Wayne-Dalton Corp. Part No. 325809 Rev.5 7/16/2008
FOR RESIDENTIAL SECTIONAL OVERHEAD GARAGE DOORS ONLY!
DO NOT USE ON ONE PIECE DOORS!
IMPORTANT! THE DOOR AND OPENER WILL NOT FUNCTION PROPERLY UNTIL
INFRARED SAFETY SENSORS ARE INSTALLED AND PROPERLY ADJUSTED!
GARAGE DOORS & OPENERS

Wayne-Dalton Prodrive 3222C Specifications

General

Type	Chain Drive
Horsepower	1/2 HP
Voltage	120V
Frequency	60 Hz
Safety Sensors	Yes
Battery Backup	No
Remote Controls	2 included

Summary

Prodrive Garage Door Opener Manual Overview

Pre-Installation Door Inspection

Instructions for checking garage door balance and smooth operation before opener installation.

Initial Pre-Installation Checks

Important Installation Instructions

Essential safety warnings and instructions for a correct and safe garage door opener installation.

Core Installation Procedures

Attaching Opener to Rail

Steps for securely connecting the opener unit to the rail assembly, ensuring proper alignment.

Front Wall Bracket Installation

Instructions for reinforcing the header wall and mounting the front wall bracket for the opener.

Attaching Unit to Front Wall Bracket

Positioning Motor End of Opener

Mounting Opener End

Steps for securely mounting the opener's end to the ceiling joist or support structure.

Mounting Door Bracket

Wired Infrared Safety Sensor Installation

Steps for mounting the wall brackets and attaching the infrared safety sensors.

Wiring Infrared Safety Sensors

Connecting Trolley to Latch Assembly

Alignment of Wired Infrared Safety Sensors

Steps to properly align the safety sensors for correct operation and safety.

Setting Trolley Close Position

Connecting Door Arm to Door

Mounting Door Bracket for 9700 Series Doors

Mounting Door Bracket for 9100/9400/9600 Series Doors

Setting Trolley Position with TorqueMaster/Extension Springs

Setting Trolley Position with Torsion Springs

Configuration, Testing, and Programming

Setting Door Travel Limits

Adjusting the door's closing and opening travel limits for optimal performance and safety.

Obstruction Sensing Tests

Performing contact and safety sensor obstruction tests to ensure proper reversal mechanisms.

Wired Wall Station Installation

Wireless Wall Station Installation

Programming Wireless Keyless Entry

Primary Programming for HomeLink®

Alternate Programming for HomeLink®

Programming Wireless Wall Stations or Transmitters

Adjustment Procedures

Guide for adjusting opening/closing force, obstruction sensing, and mechanical door lock.

Operation, Maintenance, and Troubleshooting

Important Safety Instructions and Door Activation

Key safety warnings, emergency disconnect procedures, and how door activation signals work.

Troubleshooting Common Issues

A guide to diagnosing and resolving common problems with the garage door opener system.