To Next PageTo Next Page
Need help?Do you have a question about the Wayne-Dalton Prodrive 3222C-Z and is the answer not in the manual?
General| Horsepower | 1/2 HP |
|---|---|
| Type | Chain Drive |
| Voltage | 120V |
| Frequency | 60 Hz |
| Security | Rolling Code Technology |
| Maximum Door Height | 7 feet |
| Remote Controls Included | 2 |
| Battery Backup | No |
| Warranty | Lifetime Motor Warranty |
Independent force adjustments and automatic reversal upon obstruction.
Detect obstructions in the door path, causing reversal.
Crucial safety test for proper door reversal upon contact with an obstruction.
Avoid using sensitivity settings to fix door issues; it compromises safety.
Safety test requirement for infrared sensors detecting a 6" obstruction.
Ensures proper alignment of driver gear with rail sprockets to prevent gear failure.
Warns against tampering with the spring system due to extreme tension and risk of injury.
Critical instruction to use a 2x4 board to prevent door damage when positioning the opener.
Critical instruction to position the trolley close to the opener before opening the door.
Caution against using gear cap bolts for hangers to prevent misalignment and damage.
Specific instruction to use the door-supplied bracket for certain Wayne-Dalton door models.
Critical advice to reinforce the door, consulting the manufacturer for proper methods.
Warning to install the wall station out of children's reach and in a visible location.
Critical instruction to mount both sensor brackets at the same height for proper alignment.
Critical warning against altering the power cord to prevent electrical shock.
Essential requirement to connect the opener to a properly grounded 3-prong outlet.
Warning to keep people clear of the moving door arm during testing.
States that opener operation is dependent on properly aligned safety sensors.
Warning to keep people and objects clear of the moving door arm during operation.
Warning that failure to use locking nuts can lead to arm release and potential injury or damage.
Critical warning about severe injury risk if tests fail and adjustments are not made.
Warning against being under the descending door during testing to prevent severe injury.
Critical instruction to install wall controls out of reach of children and with door visibility.
Critical warning to disconnect power at the fuse/breaker box before wiring.
Essential instruction to check and comply with local electrical codes for permanent wiring.
Critical instruction for securely attaching the opener/trolley bracket to specific door series.
Emphasizes the importance of reading and adhering to all provided instructions.
Warning against children operating controls or playing with the opener.
Advise to always monitor the moving door and keep clear of its path.
Warning against going under a stopped or partially open garage door.
Mandates monthly testing of door reversal on contact and sensor obstruction.
Crucial instruction to keep the garage door properly balanced for safety.
Warning that overriding safety sensors requires immediate correction due to severe injury risk.
Critical warning to disengage the opener during HomeLink® programming to prevent injury.
Adjusts opener force for safe closing and stopping during upward travel.
Adjusts the opener's response to obstructions during closing.
Warning that the garage door may operate during programming, requiring clearance.
