To Next PageTo Next Page
Need help?Do you have a question about the Wayne-Dalton Prodrive 3320B and is the answer not in the manual?
General| Horsepower | 1/2 HP |
|---|---|
| Frequency | 60 Hz |
| Safety Sensors | Yes |
| Voltage | 120V |
| Remote Control | Yes |
Verify the garage door is a sectional type, not a one-piece door, for safe opener installation.
Perform two tests to ensure the door is balanced and operates smoothly before installation.
Ensure the opener's limit switch is set to the door's closed position before assembly.
Thoroughly read and understand all installation steps before proceeding.
Ensure the garage door is properly balanced and serviced before opener installation.
Test door reversal with a 1-1/2" high object or 2x4 board after installation.
Mount wall station within sight of door, 5ft high, away from moving parts.
Test safety sensors with a 6" high object to ensure proper reversal.
Adjust sensor units until the alignment light on the receiving unit illuminates.
Test opener operation to ensure full open and close cycles are achieved.
Verify trolley position is 11"-13" from door and adjust using close travel screw.
Test door reversal upon contact with a 1-1/2" object on the floor.
Test sensor function with a 6" object to ensure door stops or reverses.
Adhere to all safety warnings and instructions to prevent injury or death.
Perform monthly tests to ensure proper safety reversal functions.
Understand how the opener reacts to activation, obstructions, and safety sensors.
Adjust force settings to ensure safe door reversal and prevent excessive strain.
Ensure door reverses properly upon contact with a 2x4 on the floor.
Adjust the mechanical lock to secure the door in the fully closed position.
Check power, wiring, or motor protector if opener is unresponsive.
Adjust open limit setting if the door does not open completely.
Check for obstructions or adjust closing force if door reverses prematurely.
