Wayne-Dalton 8000 User Manual

This Installation document is available at no charge from:
- Your local Wayne Dalton Sales Center, or
- Online at www.Wayne-Dalton.com, or
- By mailing to: Wayne Dalton, a division of Overhead Door Corporation, P.O. Box
67, Mt. Hope, OH., 44660
©Copyright 2017
REV12_04/25/2017Part Number
Table Of Contents
346450
PLEASE DO NOT RETURN THIS PRODUCT
TO THE STORE
If you need assistance, please call 1-866-
569-3799 (press Option 1) and follow the
prompts to contact a customer service
representative. They will be happy to handle
any questions that you may have.
Pre-Installation 2
Important Safety Instructions 2
Removing an Existing Door and Preparing the Opening 2
Package Contents 3
Door Section Identification 4
Tools Required 4
Breakdown Of Parts 5
Door Installation Instructions 6
Counterbalance Installation Instructions 10
Optional Installation 16
TorqueMaster
®
Plus Reset Instructions 16
Inside Lock 16
Pull Down Rope 16
Maintenance 18
Cleaning Your Garage Door 18
Painting Your Garage Door 18
Maintaining The Finish On Your Garage Door 18
Operation And Maintenance 18
Warranty 20
Wayne Dalton, a division of Overhead Door Corporation
Models 8000 / 8100
/ 8200
T o r q u e M a s T e r
®
P l u s
InsTallaTIon InsTrucTIons and owner’s
Manual
resIdenTIal
sTandard lIfT
To avoid possible injury, read and fully understand the enclosed
instructions carefully before installing and operating the garage door. Pay
close attention to all warnings and notes. After installation is complete,
fasten this manual near garage door for easy reference.
IMPORTANT NOTICES!

Wayne-Dalton 8000 Specifications

General

Drive	Chain
Horsepower	1/2 HP
Remote Control	Yes
Battery Backup	No
Security	Rolling Code
Speed	7.0 in/sec

Summary

Pre-Installation

Important Safety Instructions

Crucial safety guidelines and warnings for installation and operation.

Removing an Existing Door and Preparing the Opening

Steps to remove the old door and prepare the opening for new installation.

Door Installation Instructions

Attaching Flag Angles and Jamb Brackets To Vertical Tracks

Attaching Horizontal Track Angles

Attaching Bottom Corner Brackets

Attaching Hinges and Strut(s) To Sections

Attaching Vertical Tracks To Jambs

Attaching Top Fixtures To Top Section

Stacking Sections

Attaching Horizontal Tracks

Counterbalance Installation Instructions

Preparing The TorqueMaster® Spring Tube Assembly

Instructions for preparing the TorqueMaster® spring tube assembly for installation.

Installing Cable Drum Assemblies

Steps for installing the cable drum assemblies onto the spring tube.

Attaching End Brackets To Flag Angles

Procedure for attaching end brackets to the flag angles.

Attaching Center Bracket to Wall

Instructions for securing the center bracket to the wall.

Securing Door For Winding Spring(s)

Steps to secure the door before winding springs.

Adjusting Counterbalance Lift Cable

Procedure for adjusting the counterbalance lift cable tension.

Winding Spring(s)

Detailed instructions for safely winding the garage door springs.

Attaching Rear Back Hangs

Balancing Door

Optional Installation

TorqueMaster® Plus Reset Instructions

Procedure for resetting the TorqueMaster® Plus safety system.