38
Wayne Engineering
TM
, a subsidiary of Eyecarrot Innovations Corp. in Canada, is the leading provider of high-performance
instruments for testing and enhancing visual and motor skills. Learn more at www.wayneengineering.com and www.eyecarrot.com.
Modifying and Restoring Pre-set Programs
Modifying A Program
Select the basic program you wish to modify:
1. Depress the "enter" key.
2. Depress the "9" key.
3. Enter the number for the selected program.
4. Depress the "enter" key.
It can now be modified as follows:
Change the activity
Depress key #1 and enter the new number (under activity) from Parameters and Selections.
Press "enter".
Change the time:
Depress key #2 and enter the new time (in seconds). Press "enter".
Change lights speed:
Depress key #3 and enter the new light speed in lights/minute . Press "enter".
Change "time-out":
Depress key #6 and enter new "time-out" in 1/10 seconds units (i.e., "8" is 0.8 sec., "20" is 2.0
seconds). Press "enter".
Change "flash" time (light flashes "on-off")
Depress the #7 key and enter the "flash" time in milliseconds. Press "enter". If 25 was entered,
the light flashes "on" for 25 milliseconds and then turns off.
After the modifications are made, you may press the reset button to test out your new program.
Do not switch off the main power; if you do, the modified program returns to its original
program. The modified program must now be stored into memory.
If you are using a Wayne Sports Vision Trainer you can modify the preset programs as follows:
Select the listed program, press ENTER, Now press "0",AND
1. Press 66 (0-66) and press ENTER Sets 66 lights mode. (Right and left side of unit.
2. Press 33 (0-33)and press ENTER Sets 33 lights mode (Right sides)
3. Press 21 (0-21)press ENTER uses the 9 oclock light on the right side of the board for central
fixation light use in peripheral awareness modes for the full board.
4. Press 20 (0-20)press ENTER uses the normal center fixation lights in the right and left sides of the
unit.
5. Press 11 (0-11) press ENTER, Auditory Que for peripheral programs.
6. Press 12 (0-12) press ENTER No auditory Que for peripheral programs.
To Next Page
Loading...
Need help?
General