Unboxing the Pump Box
Please follow these instructions to properly unbox the Pump Box:
1. Cut the straps that wrap the box and cut the tape on the top of the box to unfold its flaps.
DO NOT make a deep cut into the box as you will scratch the Pump Box.
2. Remove the surrounding packaging.
3. (Two-person lift) With one person on each side, grab the bottom of the two aluminum side
plates, lift the Pump Box and place it near its final location. Be careful not to allow your fingers
to be pinched as you set the it down.
4. Carefully open and remove the unit from the bag that it is wrapped in. There may be some
residual water from the testing process.
5. Leave access to the Pump Box’s rear connections. We strongly recommend placing the unit
on the ground directly underneath or near WAZER. Make sure it is easy to see the Pump Box
so that you can easily detect leaks.
6. Inspect the unit exterior for any damage. This includes scratches, dents or cracks to the
exterior of the WAZER pump box.
ONLY lift the Pump Box using the bottom of the silver plates on the left and
right sides. We recommend you to retain the packaging for return and decommissioning, if
required.
Verify Your Shipment’s Contents
In an effort to improve your WAZER experience, there may be additional items that we include with
your shipment. It is likely they are included to aid in the setup, maintenance, or operation of your
WAZER.
• 1x – User Manual
• 1x - WAZER Main Unit
• 1x - Pump Box
• 1x - WAZER Power Cable (GFCI/PRCD)
• 1x - Water Filter Kit
Setup Kit
• 1x - SD Card
• 1x - Pump Vent Cap
• 1x - 17mm Wrench
• 2x - Water Sensor
• 1x - Wall Anchor Kit
1x - Wall Mount Bracket
3x - Sheet Rock Anchor
3x - Sheet Rock Fastener
3x - Concrete Wall Anchor
2x - M5x10 Hex Screws
1x - 4 mm Allen Key
Plumbing Kit
• 1x - Garden Hose Adapter
• 1x - Sink Adapter
• 1x - Sink Drain Adapter Kit
• 1x - On/Off Valve
• 8x - #3 Hose Routing Anchors
• 8x - #4 Hose Routing Anchors
• 10x - 6" Zip-Ties
Spare Parts and Toolkit
• 2x - Fuse
• 1x - Nozzle Height Tool
• 1x - Nozzle Cover
• 1x - Abrasive Hose
• 2x - Abrasive Hose End
• 1x - Orifice
• 2x - Abrasive O-ring
• 12x - 25 mm Fastening Screws
• 12x - 40 mm Fastening Screws
• 1x - Cut Bed Installation Tool
• 2x - Abrasive Plug
• 4x - High-Pressure O-Ring
• 1x - Phillips #2 Driver
• 1x - Needle Nose Pliers
• 1x - Deburring Tool
• 1x - File
Hose Kit
• 1x - High-Pressure Hose (sturdy black hose
with metal connectors)
• 1x - Water Inlet Hose (3/8” diameter white
hose)
• 1x - Water Drain Hose (1/2” diameter white
hose)
Oil Kit
• -1x - Oil
• 1x - Oil Funnel
Setting Up WAZER |
SECTION 4
32 33
To Next Page
Loading...