Wazer Main Unit - Cutting with WAZER Checklist

To Next Page

To Previous Page

NEVER skip any Startup or Shutdown steps. Failure to complete these steps

could lead to injury and damage to WAZER and your property.

We suggest you take this page out of the User Manual and leave it near your WAZER.

Cutting with WAZER Checklist

1. Preparation

 Wear proper Personal Protective

Equipment

 Open the On/Off Valve

 Fill the Tank

 Once dry, brush away used abrasive

on door window, bellows, and side

of tank

 Level the Cut Bed

 Check Water Drain Hose Location

and Attachmen

 Check for Leaks

 Confirm all Electrical Connections

(Check GFCI/PRCD functions)

 Check Position the Water Sensor

Alarms

 Machine Power On

2. Cut Setup

 Insert the SD Card

 Turn on WAZER

 Select the File to Cut

 Follow the Control Panel Prompts

- Lift the Nozzle

- Home WAZER

- Load Abrasive

- Empty the Used Abrasive Buckets

- Confirm the Water Supply is On

- Fasten the Material

- Set the Nozzle Height

- Check Cut Extents & Dry Run

- Shut door

3. Cutting

 Listen for the pierce through the

material

 Check the pressure gauge reading

 Pay attention to the following

- Pop-Ups

- Abrasive Clogs

- Partial Cutting

- Leaks

- Abnormal sounds

4. Shutdown

 Run Tank Cleaning Cycle

 Clean abrasive hose end, check

condition of O-ring, and re-seat

hose end into cutting head

 Close the On/Off Valve

 Turn WAZER Off

 Empty the Used Abrasive

 Leave the Door Open