Step 7 Click OK, the device restarts and saves the settings automatically.
----End
4.5 Configuring the Alarm Function
4.5.1 Setting Disk Alarm Parameters
Procedure
Step 1 Choose Configuration >Alarm > Disk Alarm.
The Disk Alarm page is displayed, as shown in Figure 4-17.
Figure 4-17 Disk Alarm page
Step 2 Click the button on to enable disk alarm.
Step 3 Configure the alarm interval parameters.
Step 4 Click Apply.
The message "Apply succeed" is displayed and the system saves the settings.
----End
4.5.2 Setting Network Alarm Parameters
Procedure
Step 1 Choose Configuration >Alarm > Network Alarm.
The Network Alarm page is displayed, as shown in Figure 4-18.