Webasto BlueCool V-Series - Page 11

11
Fault
code
Description Possible cause Correction
Display
A01
Compressor
shut-down due
to low pressure
Wrong low pressure
sensor reading.
Please contact your au-
thorised Webasto Marine
dealer.
COOLING MODE:
Cold water flow
rate too low.
Check operation of the
cold water pump. If fitted,
open shut-off cock valves.
Please contact your au-
thorised Webasto Marine
dealer.
HEATING MODE:
-Sea water flow
rate insucient or
sea water too cold
(Temperature below
6 °C).
-Sea water strainer
blocked or no
intake.
Remove blockage at sea
water inlet. Check/clean
sea water strainer and
bleed sea water circuit.
Refrigerant short-
age.
Please contact your au-
thorised Webasto Marine
dealer.