Installation
www.webasto.us Webasto Product N.A., Inc. www.techwebasto.com
17
Avoid asphyxiation! If the exhaust pipe is routed through the inside of the vessel, exhaust gas tube must be as leakproof as
possible:
• use only Webasto approved exhaust clamps and firmly tighten clamps.
• an approved exhaust sealant can be used on the inside of the exhaust tube at all connection points
• use condensation water drain
• if desired, use an optional gas tight exhaust muffler to reduce interior noise
•DO NOT fit the skin fitting below the water line.
•DO NOT cover the exhaust while the heater is in operation.
• DO fit the skin fitting as high as possible to avoid ingress of water.
• DO make sure exhaust clamps are tight and fit well to avoid gas escape.
• DO make sure that exhaust fumes cannot reach the air intake.
WARNING
CAUTION
To Next Page
Loading...
Need help?
General
