Foreword
www.webasto.us Webasto Product N.A., Inc. www.techwebasto.com
5
Safety and Important Information
Failure to follow the installation instructions and the notes contained therein will lead to all liability being refused by
Webasto Product. The same applies if repairs are carried out incorrectly or with the use of parts other than genuine spare
parts.
All Webasto BlueCool (WBC) products are 110 or 220 volt components that are only allowed to be installed, connected and
maintained by trained and duly certified personnel. The electrical power supply must be permanently disconnected before
any work is started on the systems.
The year in which the heater is used for the first time must be permanently recorded on the heater’s factory plate by deleting
the inapplicable year figures.
The heater must not be operated:
• In filling stations
• In places where explosive vapors or dust may build up (e.g. near fuel, coal, wood, or dust).
• In enclosed rooms (e.g. winter storage facilities)
The heater must not:
• Be exposed to temperatures of more than 248°F (120 °C) (storage temperature), otherwise the electronics may
suffer permanent damage.
The heater must:
• Be operated with the fuel specified on the factory plate.
• Be switched off if considerable quantities of smoke is generated, in case of unusual combustion noises or if you
smell fuel. Switch it off by removing the fuse. The heater must not be restarted until the unit has been checked by
personnel duly trained by Webasto.
• Be operated for 10 minutes at least once a month. The heater must be inspected by a specialist at the beginning of
the heating season or earlier.
To Next Page
Loading...
Need help?
General
