Roof-Mounted Air Conditioner KK2000 E
Page 19 / 30
4.2 Checklist for the Installation of the KK2000 E with Heater Unit
• In the heater unit’s combustion air intake line, make an hole of 11 mm inner diameter
if the exhaust and intake lines do not exceed 4.5 meters.
• The heater unit’s combustion air intake line must be at least 600 mm.
• Make sure the complete fuel guide to the heater unit is filled before the first
initialization.
• Fasten the fuel line for the heater unit in the KK2000 E with the clamp provided on
the base plate in the system so that the fuel line cannot be damaged by the hot
exhaust pipe.
• If a fuel filter is installed for the heater unit, then this must be replaced yearly.
• To install the heater unit, the information in the installation instructions, ID no. 776
252, must also be observed.
• The hot air tube duct from the KK2000 E system to the cabin must be sealed
completely.
To Next Page
Loading...
