Webb Werr17 - Before you begin; Fill oil sump with oil

User’s manual
7
Before you begin.
WARNING! The following procedures must be carried out before you
start the engine of your lawnmower.
1. Fill oil sump with oil.
The mower is NOT supplied with oil in
the engine, add 591ml SAE30 oil before
starting the engine for the
first time.
Firstly, remove the warning label from under
the dipstick, then remove the dipstick
and slowly pour 591ml SAE30 oil into the
engine via the oil filler. Replace the dipstick
and tighten.
Before you use the mower each time, check
the oil level and if necessary top up with
SAE30 engine oil. To check the oil level,
just unscrew the yellow dipstick, wipe clean
and replace into the oil filler, remove it
again to check the oil level. The
oil level
must be between the min and max marks on
the dipstick.