18
1
2
3
CONNECTING THE HOSE TO THE LP
TANK
A) Remove the plastic dust cover from the tank valve.
B) Screw the tank adapter hose onto the tank valve,
turning clockwise, or to the right (1).
Hand-tighten only.
NOTE: This connection tightens clockwise and will not
allow gas to flow unless the connection is tight.
WARNING: Do not use a wrench
to tighten the connection. Using a
wrench could damage the adapter
hose coupling and could cause a
leak.
REMOVING THE LP TANK FOR
REFILLING OR REPLACEMENT
A full LP tank will last about 18–20 hours of cooking
time at normal use. You do not have to run out of fuel
before you can refill the tank. In fact, we recommend
that you refill the LP tank before it is completely empty.
Removal of the LP Tank
A) Close tank valve (turn clockwise) (2).
B) Unscrew regulator coupling by turning
counterclockwise, by hand only (3).
C) Unbuckle the tank strap. Lift tank off tankrest.
FILLING THE LP GAS TANK
Proper filling of your tank is done by weight or volume,
as described in NFPA 58. Please make sure your filling
station uses one of these two methods, and ask your
filling station to read the purging and filling instructions
on the LP tank before attempting to fill it.
WARNING: We recommend that your
LP tank be filled at an authorized
LP gas dealer, by a qualified
attendant, who fills the tank by
weight. IMPROPER FILLING IS
DANGEROUS.
NOTE: Be certain tank is purged of trapped air prior to
first filling. Your LP dealer is equipped to do this.
GAS INSTRUCTIONS
To Next Page
Loading...
Need help?
General
