Weber SmokeFire EPX4 - Page 28

28
TROUBLESHOOTING
1
2
3
4
A
F
B
C
D
E
E3 Grill Flame is Out
Grill Flame Out Procedure
To clear the E3 error code from the controller, please follow these steps:
1. The grill will automatically run the shutdown procedure if the grill is
still hot. Open the grill lid and wait until the grill has completed the
shutdown procedure and completely cooled.
CAUTION: Do not unplug the grill or power it o during the shutdown
procedure.
2. Once the shutdown procedure is complete, power o the grill and
unplug from power source.
3. Open the grill lid and remove the cooking grates, FLAVORIZER bars,
heat diuser, and heat bae from the cookbox (A).
4. Clean the cookbox and burn pot of any ash or debris using a grill
brush or scraper to direct it into the ash and grease system (B).
CAUTION: Allow time for the ash and debris to fully extinguish before cleaning
the grill.
5. From the rear of your SMOKEFIRE grill, place a large bucket or
container underneath the middle of the hopper (C).
6. Pull the hopper slide door located on the rear of the hopper to
release the pellets into the container below (D). Scoop any excess
pellets left inside the hopper through the hopper slide door.
7. From the rear of your SMOKEFIRE grill, remove the rear access panel
by removing four screws (E).
8. Disconnect wire connection from the motor by pinching the clip and
pulling the quick disconnect plug. (F).