Weber SmokeFire EPX4 - Page 35

35
8. Install the replacement glow plug into the glow plug shuttle by firmly
pushing it into the socket (G).
9. Carefully reinstall the glow plug shuttle straight through the back of
the grill, and secure it in place by tightening the screw (H).
NOTE: Be sure that the tip of the glow plug has been properly installed by
visually inspecting the glow plug at the bottom of the burn pot inside the
cookbox. The tip of the glow plug must be inserted through the pellet grate for
proper operation (I).
10. Reconnect the glow plug shuttle wires to the back of the glow plug
shuttle (J).
11. Reinstall the rear access panel (K).
12. Reinstall the heat bae, heat diuser, FLAVORIZER bars and cooking
grates inside the cookbox. (L).
13. Plug the power cord into the grill located underneath the hopper,
then plug the grill into a power source.
14. Power on the grill and confirm replacement of the glow plug within
the main menu settings of the controller.
TROUBLESHOOTING
I
1
2
3
4
L
G
H
J
K
weber.com