WECO 5K3-XP RACK LV-EMEA
3
Version 11/11/2021
Statement:
The information and guidance contained in this manual are related to the WECO 5K3-XP RACK model of
battery. This manual contains two sections:
Section I is for GENERAL OVERVIEW
Section II is for LOW VOLTAGE CONFIGURATION
In case of product upgrades or other reasons, this document will be adjusted accordingly. Unless otherwise
agreed, this document is intended to be used only as a guide, and all statements, information and advice in the
documentation shall not constitute any express or implied action in contradiction to local regulations or
standards.
For more information, please contact us.
The official information and the latest data sheet are available on www.wecobatteries.com
It is essential that the Battery Module is equipped with the latest firmware version available. New batteries
always ship with the latest version of the firmware.
From time to time, the firmware will be updated to improve the functionalities and battery capabilities. The
latest version of the firmware is always available free of charge and can be updated by your local installer. You
can always contact service@wecobatteries.com for additional information on the upgrade procedure.
Preface:
Thank you for choosing our product. We will provide you with a high-quality product as well as reliable after-
sales service. To protect against harm to both personnel and the product, please read this manual carefully.
This manual provides detailed information on the operation, maintenance and troubleshooting of the product,
as well as health and safety advice.
Declaration:
The manufacturer holds the right to a final explanation of any content in this manual.
All trademarks shown in this manual belong to their legitimate owners; trademarks of third parties, product
names, trade names, corporate names, and companies mentioned may be trademarks owned by their
respective owners or registered trademarks of other companies and are used purely for explanatory purposes
and for the benefit of the owner, without any purpose of violation of the copyright in force.
NOTICE:
This Battery Module is designed to be used in cabinets. Cabinets can be either IP 30 or IP 54, but in
case of cabinet IP 54 it is suggested to use an auxiliary cooling system
The STANDARD IP20 degree of protection does not allow installation in outdoor environments even
if sheltered from the weather.
The Battery Modules must be stored indoors in a clean, dry, cool location in a limited access area.
To Next Page
Loading...