EasyManuals Logo

WEG CFW100 - IOADR User Manual

WEG CFW100 - IOADR
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Infrared Remote Control and I/O
Expansion Module
English
12 | CFW100
NOTE!
When the NTC sensor is not connected to the
accessory, the CFW100 frequency inverter will
show 999 °C (1830 °F) in parameter P375.
If pins 6 and 7 (accessory connector) are
short circuited, the value shown in P375 will
be 0 °C (32 °F).
ATTENTION!
Some keys of the remote control have different
functions according to the operating status
of the CFW100 frequency inverter when the
user application (P903 = 0) is installed and it
is running (P900 = 4).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WEG CFW100 - IOADR and is the answer not in the manual?

WEG CFW100 - IOADR Specifications

General IconGeneral
CategoryRemote Control
ModelCFW100 - IOADR
Output Voltage24 Vdc
Protection DegreeIP20
Relative Humidity5% to 95% (non-condensing)