Summary
3.2.10 RS-485,XC8 Isolated SerialCommunication
Board Connection .................................................................... 48
3.2.11 XC6 Fieldbus Communication BoardConnection ...................... 48
3.3RecommendedSet-Ups.................................................................... 48
3.3.1 Recommended Set-ups byKeypad (HMI) Command
with Isolating Contactor. Notes in 3 .3. ....................................... 50
3.3.2 Recommended Set-ups byKeypad (HMI) Command
with Circuit-breaker. Notes in 3.3................................................ 50
3.3.3 Recommended Set-ups with Command viaTwo-wire
Digital Inputs. Notes in 3.3. ........................................................ 51
3.3.4 Recommended Set-ups with Command via Three-wire
Digital Inputs. Notes in 3.3. ........................................................ 51
3.3.5 Recommended Set-ups with Command via Three-wire
Digital Input and Inside Delta Motor Connection. Notes in 3.3
and 3.2.5.2. ................................................................................ 52
3.3.6 Recommended Set-ups with Command via Three-wire
Digital Input or Serial Communication. Notes in 3.3. .................. 52
3.3.7 Recommended Set-ups with Command via Three-wire
Digital Input or Fieldbus Communication. Notes in 3.3. .............. 53
3.3.8 Recommended Setup with Commandvia Digital Inputs and
direction of rotation ..................................................................... 53
3.3.9 Recommended Setup with Commandvia Digital Inputs and
Reverse Braking ......................................................................... 54
3.3.10Recommended Setup with Command via Digital Inputs and
Optimal Braking ....................................................................... 54
3.3.11 Recommended Setup with Command via Digital Inputs and
DC-Braking............................................................................... 55
3.3.12Recommended Setup with Command via Digital Inputs and
External By-pass Contactor ..................................................... 55
3.3.13 Symbols ................................................................................... 56
3.4 European Directives for Electromagnetic Compatibility
Requirements for installation .......................................................... 57
3.4.1 Installation .................................................................................. 57
CHAPTER 4
Keypad (HMI) Operation
4.1 Description of the Keypad (HMI-SSW-06) ..................................... 59
4.2 Use of the Keypad (HMI) ................................................................ 61
4.2.1 Keypad Use for Soft-Starter SSW-06 Operation ......................... 61
4.2.2 HMI Display-Signaling indications............................................... 62
4.2.3 Parameter Viewing and Programming......................................... 63
CHAPTER 5
Start-up
5.1 Power-upPreparation ..................................................................... 65
5.2 InitialPower-up ............................................................................... 66
5.3 Start-up........................................................................................... 73
5.3.1 Start-up Operation via Keypad (HMI) -