Need help?Do you have a question about the WEG SSW900 Series and is the answer not in the manual?
General| Type | Soft Starter |
|---|---|
| Input Frequency | 50/60 Hz |
| Output Current | Same as Current Range |
| Control Method | Voltage ramp, current limit, torque control |
| Protection Features | Overload, overcurrent, phase loss, overtemperature, short circuit |
| Communication Protocols | Modbus RTU, Profibus DP, Ethernet/IP |
| Bypass Contactor | Integrated (depending on model) |
| Enclosure Rating | IP20 |
| Humidity | Up to 95% non-condensing |
| Dimensions | Varies by model |
| Weight | Varies by model |
Details the specific Anybus PROFINET IO communication module and its supplied items.
Explains IP addressing methods (parameter/DHCP) and device naming for PROFINET.
Explains the bits of the SSW status word for monitoring device operation.
Describes the command word for controlling the SSW from various sources.
Details configuration for communication accessories and protocols.
Configures the network data exchange area for cyclic communication.
Configures parameters for reading data over the network.
Explains cyclic data usage for status monitoring and equipment control.
Configures the reading area for cyclic data exchange (inputs sent to master).
Maps parameters to specific input words for cyclic data communication.
Configures the writing area for cyclic data exchange (outputs received from master).
Maps parameters to specific output words for cyclic data communication.
Guides on configuring the soft-starter parameters and communication settings.
Steps for configuring the PROFINET IO network master using the GSDML file.
To Next Page
