Need help?Do you have a question about the WEG SSW06 and is the answer not in the manual?
General| Brand | WEG |
|---|---|
| Model | SSW06 |
| Category | Controller |
| Language | English |
Explains physical wiring of power and ground connections for the soft starter.
Guides through the initial parameter setup for proper operation and protection.
Details the common voltage ramp method for motor acceleration and start-up.
Covers operating modes and 2-wire start/stop control wiring connections.
Details 3-wire start/stop control and signal input/output connections.
Explains displayed fault codes and methods to reset the soft starter after a fault.
To Next Page
