Need help?Do you have a question about the WEG SSW-05 and is the answer not in the manual?
General| Brand | WEG |
|---|---|
| Model | SSW-05 |
| Category | Controller |
| Language | English |
Illustrates a basic wiring diagram for starting and stopping the motor on a 230V/400V line.
Details the conditions and activation for Overcurrent and Phase Loss protections.
Explains the Incorrect Phase Sequence and Locked Rotor fault protections and their indicators.
Covers Motor Overload, Overcurrent of the By-pass relay, and Overcurrent before By-pass protections.
Describes Thyristor Overload, Frequency out of Tolerance, and Internal By-pass relay status.
Details the Undercurrent protection mechanism and its activation conditions.
Explains the motor electronic overload protection, simulating motor thermal image and its curve.
Details methods for resetting faults, including manual reset via button/DI2 and automatic reset functions.
Details the fault display (E03), reset methods, and possible causes for Phase Loss.
Explains Motor Overload faults (E05), including display, reset, and potential causes.
Covers External Fault (E06) and Error in Copy Function (E10) with their causes and resets.
Details Keypad Connection Fault (E31) and Locked Rotor (E63) fault handling.
Explains Thyristor Overload (E64) and Undercurrent (E65) faults, including their causes and resets.
Details Overcurrent (E66) and Incorrect Phase Sequence (E67) faults and their resolution.
Covers Undervoltage in Control Supply faults (E70), including causes and reset methods.
Details Internal By-pass Relay faults (E71) and Overcurrent before/of By-pass (E72, E73).
Explains Frequency out of tolerance faults (E75), including their causes and reset procedures.
Provides solutions for frequent issues like motor not running or speed oscillation.
Provides a list of error codes (E03-E75) and their corresponding descriptions for troubleshooting.
Shows the mapping of enabled diagnostics to hexadecimal values for programming P106.
Describes the procedure for copying parameters between SSW units using the HMI keypad.
Outlines compliance with EMC and LVD directives and relevant standards.
Lists the standards the SSW-05 Soft-Starter is designed to and its conformity declarations.
To Next Page
