6 | W21 Magnet Drive System
®
Quick Guide
4 - Configuration of the inverter
Figure - HMI of Inverter
Key Name Function
Menu Key
Enter function menu when standby or running. Press this key to return when modifying
parameter. Press for 1 sec to enter condition monitoring interface when in standby or running
condition.
Confirm/
modify key
Press to modify parameter when in menu interface. Press again to confirm after modifying.
Press to change LED monitoring items at down time when in standby or running condition.
Up/down
key
Select parameter group in menu interface. Modify parameter in modifying interface. Modify
given frequency, PID, given torque or magnetic powder clutch given torque when at standby
or condition monitoring state (When given frequency, PID, given torque or magnetic powder
clutch given torque are set by keyboard, please set [F4.04])
Shift key
Select digit of function number modified by up/down key; Select
parameter digits modified by up/down key.
4.1 - Inverter’s key functions
Forward run
key
When run/stop is controlled by keyboard, press this key, the inverter forwardly rotate and the
indicator is always on. When reverse, the indicator sparks.
Jog/reverse
key
This key function can be defined by parameter [F4.02]. Press it, the machine reverses and
indicator is off if this key is defined as REVERSE; the machine jogs and indicator is on if this
key is defined as JOG.
Stop/reset
key
The machine stops if press it while run/stop is controlled by keyboard. Its efficiency range is
defined via function no [F4.03]. Inverter resets if press it in fault state (the machine would not
reset if the fault is not solved).
Keyboard
potentiometer
Can be used as input channel for given frequency, upper frequency limit,
given torque, given PID or PID feedback setting
To Next Page
Loading...
