English
67
espresso coffee machine - user instructions
1
12
0
4. ACTIVATION OF THE MACHINE
Before starting the machine, make sure that the level of water in the boiler is higher than the minimum level
on the level-check window (1). If there is no water (first installation or after boiler maintenance), it is neces-
sary to fill the boiler in advance, so as to prevent overheating of the heating element.
Proceed as follows:
• Open the water tap of the water mains and of the softener.
• Turn the switch to position “1” (electrical power supplied to the pump for automatic boiler filling and
machine services) and wait for the boiler to be automatically filled with water.
• Turn the switch to position “2” (full electrical power supplied, including the heating element in the boiler)
and wait for the machine to warm up completely.
5. USE OF THE MACHINE
5.1 POD PREPARATION
• Insert the pod into the filter holder, as shown in the figure;
• hook the filter holder to the group without closing it too tightly in order to avoid excessive
wear of the seal;
2-Cup
filter holder
1-Cup
filter holder
(optional)
1-Cup filter
holder for
cappuccino
Use “LAVAZZA BLUE” pods only.
Do not insert your fi ngers into the fi lter-holder or any other object.
The pods are to be used once only.
Be careful to insert the pod in the correct fi lter holder
(with 1 or 2 spouts).
• during the machine’s warm-up phase (roughly 20 minutes), the negative pressure valve will
release steam for a few seconds until the valve itself closes.
• before using the machine, run dry deliveries with the fi lter holder attached for a few seconds
to release any air which may be in the circuit, so that the delivery groups are completely
heated.
• before using the machine, dispense a few servings of coffee to check the operating pressure
of the machine.
B
E
S
T
L
A
V
A
Z
Z
A
U
L
T
I
M
A
T
E
E
S
P
R
E
S
S
O
B
E
S
T
L
A
V
A
Z
Z
A
U
L
T
I
M
A
T
E
E
S
P
R
E
S
S
O
B
E
S
T
L
A
V
A
Z
Z
A
U
L
T
I
M
A
T
E
E
S
P
R
E
S
S
O
To Next Page
Loading...
