Weidemann Hoftrac 1190e - Page 77

5
Putting into operation 5
77
[en] | 08/2022 | 1000441528 | 1190e | Operator’s Manual
NOTICE
Damage to the compressor.
Too long operation of the suspension adjustment can
cause damage to the compressor.
► Do not operate the suspension adjustment for more
than one minute.
The individually desired height can be adjusted up to a
minimum spring travel.
ü The ignition must be switched on.
1. Pull lever 3 to the front.
ð The seat moves upwards and the suspension
travel increases.
2. Press lever 3 to the back.
ð The seat moves downwards, the suspension travel
becomes smaller.
3. Release lever 3 when the seat has reached the de-
sired position.
ð Suspension and height are adjusted.
5.2.1.4 Heated seat
I
0
Fig.47: Switch for seat
heating
If the seat has a seat heater, this is operated via the rocker
switch on the left-hand side of the backrest.
▪ Move rocker switch to position I.
ð The heated seat is switched on.
▪ Move rocker switch to position 0.
ð The heated seat is switched off.
5.2.1.5 Adjusting the height of the armrest
1
2
Fig.48: Armrest
The height of the armrest1 can be set individually.
ü The vehicle is at a standstill.
1. Loosen screw2 by turning to the left.
2. Adjust the desired height of the armrest.
3. Tighten screw2 by turning to the right.
ð The height is set.