Weider Pro 9635 - Page 11

11
13. Slide one of the Uprights (11) onto the Base
(7). Attach the Upright with an M10 x 110mm
Bolt (44), an M10 Locknut (37), four M10 x
1
8mm Screws (34), and six M10 Curved
Washers (58).
Attach the other Upright (11) to the Base (7)
in the same way.
14. Attach the tether on a Large Pin (13) to the
underside of a Weight Rest (12) with an ST4.2
x 10mm Screw (17).
Hold the Weight Rest (12) on the indicated
side of an Upright (11), and align the Weight
Rest with one of the adjustment holes in the
Upright. Insert the Large Pin (13) through the
Weight Rest and the Upright.
Attach the other Weight Rest (not shown) to
the other Upright (11) in the same way.
Attach both Weight Rests at the same
height.
11
58
34
9
34
34
34
58
58
37
7
44
1
1
12
11
13
17
11
13
14