Weider Shape Glider - Page 5

ASSEMBLY
For your convenience, the SHAPE GLIDER is shipped in the storage position. To set up the SHAPE GLIDER for
use, place it in a cleared area and remove all packing materials. Do not dispose of the packing materials until
the SHAPE GLIDER is fully set up. Setting up the SHAPE GLIDER may require a hammer (not included).
1. Remove the Lock Pin (16) from the tube under
the Base (11).
.
Raise the Upright Frame (8) and hold it in the
position shown. Insert the Lock Pin (16) through
the Upright Frame and the tube under the Base
(11). Note: It may be helpful to lubricate the
holes and use a hammer to tap in the Lock
Pin.
.
Raise the Seat (3) and hook the Link Arm (10) onto
the Butterfly Bushing (25) on the Pedal Frame (6).
Push down on the Link Arm to make sure it is
fully seated on the Butterfly Bushing.
.
Press the Spring Clip (32) in the Handlebar Post
(5). Insert the Handlebar Post into the Pedal
Frame (6). Make sure that the Spring Clip
snaps into the indicated hole in the Pedal
Frame.
To fold the SHAPE GLIDER for storage, refer to
MAINTENANCE AND STORAGE on page 9.
11
Push
Down
10
c_xi.... c __ k j ZTL___Z:ZD
5
11