Weider WEBE4496.0 - Page 21

21
42. Wrap the Low Cable (58) under a Small Pulley
(59). Attach the Small Pulley and a Cable Trap
(76) to the first hole in the Rear Base (25) with an
M10 x 50mm Bolt (111) and an M10 Nylon
Locknut (94).
43. Wrap the Low Cable (58) under a Small Pulley
(59). Attach the Small Pulley and a Cable Trap
(76) to the third hole in the Rear Base (25) with
an M10 x 50mm Bolt (111) and an M10 Nylon
Locknut (94).
42
43
94
76
111
59
58
25
94
76
25
111
58
59
41. Locate the Low Cable (58). Route the Cable
through the Center Upright (29). Attach two Small
P
ulleys (59) inside the Center Upright with two
M10 x 91mm Bolts (112), four M10 Washers (96),
a
nd two M10 Nylon Locknuts (94).
4
1
9
4
29
96
96
112
5
9
59
58