23
June, 2016
The Bag Blower’s height can be adjusted; this will change the depth at which it enters the bag. This
height is dependent on bag size, as different bags will require the Bag Blower to be readjusted to fit them
properly. The Bag Blower should sit just deep enough into the bag to form a proper seal with it prior to the
bag’s inflation, but not so deeply that it crumples the bag or causes it to slip from the fingers of the
Walking Beam.
THE BAG BLOWER SHOULD SIT
DEEP ENOUGH INTO THE BAG
TO ALLOW FOR MAXIMUM AIR
PRESSURE INTO THE BAG.
IF THE PLUNGER IS SET TOO
LOW, IT MAY PUSH THE BAG
DOWNWARDS WHEN
ENTERING.
To Next Page
Loading...
