上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
49 / 52
2. To enter into OneKey Cali interface, press → =:
3. To select target tools, do the following:
– Press ↑ / ↓ → Enter.
– Press F6, and select all tools.
– Press F6, and remove all selected tools.
4. To start instant calibration, press F1.
The system automatically changes the tool and start to calibration.
6 System Management
Through this section, you can quickly know the following operations for system
management:
• Register the system.
• Switch the system language.
• Maintain the system.
• Use NcCloud Assistant.
• Set the network.
To Next Page
Loading...
