Welby Upper Arm - Storing Measurement Values

36
Measuring and storing values
If you know that your blood pressure is higher than 230mmHg, proceed as described
on page 38.
 Press button 1 or 2 to interrupt the measurement.
 Make sure that the air tube is not kinked or being squashed.
NOTE
You can save 30 measurement values for each of two users in separate
memories.
 To store the values for the  rst user, press button 1.
 To store the values for the second user, or, if only one person uses this monitor to
store additional values, press button 2.
The selected button will light up.
 During measurement, do not move the cu or your arm or hand muscles.
After a few seconds, the monitor will pump up the cuff. When the cuff pressure is
stable, the monitor will start measuring automatically.
The current values are shown in the display.
 Press button 1 or 2 if you want to interrupt the measurement.
The cuff deflates.
12450 USA final Content REV1.indd 3612450 USA final Content REV1.indd 36 18.10.2012 12:00:1718.10.2012 12:00:17