Operation
Oral Temperature Measurement (4-6 seconds)
1. Insure that the oral probe is installed (blue ejection button and probe well)
2. Remove probe from well, unit will turn on automatically. Insure that the oral model icon
is flashing on display. If not, press Mode Selection button until head icon appears.
3. Load probe cover by inserting the probe into a probe cover and press the probe handle
down firmly.
4. Place probe tip under patient’s tongue on either side of the
mouth to reach the rear sublingual pocket. Have patient
close his/her lips around probe.
5. Hold probe in place, keeping the tip in contact with oral
tissue. Rotating “walking” segments appear on display,
indicating that measurement is in progress.
To Next Page
Loading...
