TM 262
1-4 Revised 4/11/08
The TM 262 is designed to be used with a hospital grade outlet.
Injury to personnel or damage to equipment can result when a three-prong to two-prong
adapter is connected between the TM 262 power plug and an AC outlet or extension
cord. Additionally, the TM 262 is equipped with a specific power transformer (8000-0246)
and power cord, which should not be interchanged with any other transformer or supply
and are for use only with the TM 262.
The above symbol indicates the location of a service adjustment part and is intended for
service personnel use only. The TM 262 is a specifically calibrated device and the
periodic service and adjustments which the instrument may require should be done
only by an authorized Welch Allyn service technician.
The TM 262 is designed to comply with the EMC requirements
according to IEC 60601-1-2.
Radio transmitting equipment, cellular phones, etc. shall not be used in the close
proximity of the device since this could influence the performance of the device.
Particular precaution must be considered during use of strong emission sources such
as High Frequency surgical equipment and similar so that e.g., the HF-cables are not
routed on or near the device. If in doubt, contact a qualified technician or your local
representative. Refer to the Electromagnetic Compatibility (EMC) Guide on CD 482-
638702.
WARNING
!
CAUTION
!
To Next Page
Loading...
Need help?
General
