Revised 4/11/08 3-11
Operation
Program Mode
To enter the program mode, press the PROGram pushbutton located on the front panel. The
following screen appears the first time you enter the Program mode after you receive your
instrument from the factory. These are the default settings used at the factory during
production.
Note that these selections fall into five different groups of controls:
• Reflex format for printer
• Print header format
• Audiometric test result format
• Status of normal box
• Audiogram frequency range
The default setting for each group of controls has an asterisk (*) prefix so that it is easy to scan
the settings selected for each group.
Reflex format
Reflex test results can be displayed and printed in any of the following three different ways:
• reflex dB HL plus curve
• reflex dB HL only
• reflex yes/no
The default setting for this grouping is reflex dB HL plus curve. This means that all reflex test
results will appear on the display and the printout with the following information:
a. I (Ipsi)
b. Frequency: 500, 1000, 2000, or 4000 Hz
c. Intensity level where response was detected
d. Tracing of actual response curve.
If reflex HL only is selected, the same information as shown above (except for d) will appear
on the display and the printout.
If reflex yes/no is selected, item d will not appear and item c will be replaced with the word
yes (response detected at one of three levels) or no (no response detected).
Program Mode - User Selections
* Reflex HL + Curve * Print - Audiogram
Reflex HL only Print - Aud Table
Reflex Yes/No * Normal Box ASHA
* Prn Header Welch Allyn Normal Box Off
Prn Header Off * Aud Range Normal
Prn Header Custom Aud Range Narrow
To Next Page
Loading...
Need help?
General
