Page 15
TROUBLE SHOOTING GUIDE
NOTE: If you are still having difficulty with your welder, do not hesitate to
contact our service team on:
1800 001 1812
FAULT REASON REMEDY
Overheat
Lights Come
On
Overheating of unit Allow 3—5 minutes of “cool down” time.
If condition is not resettable, take
welder to repair agent for service.
Difficulty in
Arc Starting
Damaged Electrodes Check condition of electrodes
Low voltage problem Check the AMP settings
Arc Does Not
Transfer
Loose, missing cable con-
nections
Check earth connection for loose or
poor ground
Power supply not recognis-
ing start signal
Check all connections
Extension
Cables
Ensure that any extension
cables are of adequate
capacity
Low quality/ capacity cables will result
in voltage drops and hinder starting
Check the power supply
To Next Page
Loading...
