Well Universal SWS221521 - Attach Table Legs to Table Cabinet; Attach Lower Shelf to Leg Bases

ASSEMBLY INSTRUCTIONS
3.- Attach Table Legs to Table Cabinet
Place one Table Leg (5) into the space between
the support beams
on the bottom of the Table
Cabinet as shown
in FIG. 3. Align the holes in
the Leg with the holes in the support beam and
attach the Leg to the Table Cabinet using Long
Bolts (A), Spring Washers (C) and Flat Washers
(D). Tighten slightly using the Hex Wrench (E),
but DO NOT tighten bolts completely
as slight
adjustments will need to
be made later. Repeat
this process for the other three Table Legs.
Again, DO NOT tighten bolts completely.
Hardware Used
0
LONG BOLT
~
x16
G
SPRING WASHER
~
x16
G
FLAT WASHER
@
x16
G
HEX WRENCH
~
X 1
4. -Attach Lower Shelf to Leg Bases
With assistance from another adult, place
Lower Shelf (2) and Leg Bases (6) upside
down
on a clean, soft, and smooth surface as
shown
in FIG. 4. Insert the ends of the Lower
Shelf (2) into the corresponding square
notches on each Leg Base. Attach the Lower
Shelf to the Leg Base using Long Bolts (A),
Spring Washers (C) and Flat Washers (D).
Tighten SLIGHTLY using the Hex Wrench (E),
but DO NOT tighten completely at this time as
adjustments will need to
be made later.
Hardware Used
0
LONG BOLT
~
x4
G
SPRING WASHER
~
x4
G
FLAT WASHER
@
x4
G
HEX WRENCH
~
x1
6;